Nitek FRS2020 Manuel d'utilisateur télécharger pdf

Model FRS2020 19” Rack Mount Chassis

with Dual Power Supply System

Installation and

Operation Manual

NITEK ®

De Schans 19-21 2a

8231 KA Lelystad

Tel: +31(0)320-230005

E-mail: [email protected]

WWW.NITEK.NL

USA

5410 Newport Drive, # 24

Rolling Meadows, IL 60008

Phone: (847) 259-8900

Fax: (847) 259-1300

E-mail: [email protected]

WWW.NITEK.NET

EUROPE

09172013

680160112

Reduce risk of fire or electrical shock. Do not

expose this product to rain or moisture.

Note: This installation should be made by a qualified

service person and conform with local codes.

Safety

The FSS20111S uses a Class 1 laser system in accordance with IEC 60825-1.

It is always advisable to follow good practice when working with optical fiber systems. This includes:

• Do not stare with unprotected eyes at fiber ends or connector faces.

• Use only approved filtered or attenuating viewing devices.

• For other safety issues and advice on good practices associated with optical fiber systems see IEC 60825-1 or your

local safety officer

Front View

The FRS2020 can be either rack mounted, or resting on a desktop.

NOTES:

1. Use all four mounting screws to properly secure the unit to the rack.

2. Mechanical loading - The mounting ears were designed for two ears to support one unit.

3. Air-Flow - Leave space on the rear of the unit for airflow into cooling fans on back of the unit. Adequate air flow

is required for safe operation.

4. Cable space - Allow for proper bend radius of the fiber cables exiting the front of the unit. Do not exceed the

recommended minimum bend radius of the fiber cable.

Device Mounting Options

Introduction

The Nitek FRS2020 unit provides a means of centralizing individual video data modules, from the FSS20111S system,

together in a single chassis. The FRS2020 uses the standardized dimensions for a 19 inch 2-Unit rack mounted

chassis. The chassis can accommodate, in any combination, of up to 16 video card modules from the FSS20111S

system. The chassis design supports ‘hot swapping’ of the FSS20111S ‘plug and play’ video cards, allowing the system

to be powered up while cards are removed and installed. The FRS2020 is configured as a dual power supply, both

power supplies work independently from each other. In the case of a major failure by one of the power supplies the

other supply will continue to provide the proper power to all of the video cards.

1 2

Résumé du contenu

Page 1 - NITEK ®

Model FRS2020 19” Rack Mount Chassis with Dual Power Supply System Installation and Operation Manual NITEK ® De Schans 19-21 2a 8231 KA Lelystad Tel:

Page 2 - Typical Hook-up

Installation Instructions Refer to the diagrams on the previous page and below for installation. Use best industry practices and follow all local bu

Commentaires sur ces manuels

Pas de commentaire

Nitek FRS2020 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Nitek FRS2020. Nitek FRS2020 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Nitek FRS2020