Nitek IPCOAX16 Manuel d'utilisateur télécharger pdf

Model IPCOAX16

16 Ch. Ethernet over Coax Surge Protector

Installation and

Operation Manual

Rev 052912

NITEK®

Europe Office:

De Schans 19-21 2a, 8231 KA Lelystad

The Netherlands

Tel: +31(0)320-230005

Fax: +31(0)320-282186

E-mail: [email protected]

WWW.NITEK.NL

USA Office:

5410 Newport Drive, Rolling Meadows, IL 60008

Phone: (800) 528-4343

Fax: (847) 259-1300

E-mail: [email protected]

WWW.NITEK.NET

68-016-0104

Specifications

Size 2 RU

Connection Video Standard female BNC

Clamping Voltage 58v (on all channels)

Impedance 50 and 75 ohms

Temperature -40°C to +85°C

Installation

The IPCOAX16 must be properly installed to insure maximum protection. The function of the IPCOAX16 is to

allow a surge to be routed to ground and to clamp the protected equipment video inputs to a minimum voltage.

There are three key points to remember when installing the IPCOAX16. First, provide a low impedance

connection between the IPCOAX16 and your protected equipment. This is best done by keeping the PROTECTED

coax cable connections as short as possible, ideally less than 3 feet, and using a coax with a good braid.

Second, the system should use a single ground point. Connect the grounding stud of the IPCOAX16 to a single

ground point. A single ground point is a proper building ground to which equipment grounds are connected. Ideally,

the protected equipment should be isolated from ground. If the IPCOAX16 and the protected equipment are both

grounded you will provide a parallel path to ground and a portion of the surge current can flow through that path.

Additionally, AC power line protectors should be used to complete your surge protection strategy.

Finally, the UNPROTECTED cables and wires should not be crossed with the PROTECTED cables and wires.

Crossing cables could provide a path for surge currents to bypass the DVRCOAX16 protection circuits.

Description

The IPCOAX16 is designed to provide 16 channels of

Ethernet over Coax surge protection, as well as

supporting PoE+ devices. It is cost-effective and ideally

suited for protecting multiple devices. The IPCOAX16

is rack mountable in a standard 19” rack. It installs in

minutes and provides a single easy access point for

grounding. The 16 channels use 58 volt solid-state

clamping for unmatched protection.

NITEK

OUT

11 12

Surge Protection System

OUT

11 12

115 / 230 VAC

50/60Hz

640 Watts Max

8A 250V

RISK OF FIRE -

REPLACE FUSE

AS MARKED

CAUTION

MADE IN U.S.A.

RoHS

COMPLIANT

12345678

910111213141516

LAN 1

LAN 2

ET1500

IP Camera

ET1500

Model IPCOAX16 1

Résumé du contenu

Page 1 - Model IPCOAX16

Model IPCOAX16 16 Ch. Ethernet over Coax Surge Protector Installation and Operation Manual Rev 052912 NITEK® Europe Office: De Schans 19-21 2a, 8231 K

Commentaires sur ces manuels

Pas de commentaire

Nitek IPCOAX16 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Nitek IPCOAX16. Nitek IPCOAX16 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Nitek IPCOAX16