Nitek TS515x4 Manuel d'utilisateur télécharger pdf

Note: This installation should be made by a

qualified service person and conform with local

codes.

System Specifications

TR515x4 includes the following: TS515x4 System includes the following:

(1) TR515x4 Receiver Card (1) TR515x4 Receiver Card

(4) VB37F Transmitters

Model TR515x4

Modular Active Video Receiver Card

Installation and

Operation Manual

Rev 030111

NITEK®

Europe Office:

De Schans 19-21 2a, 8231 KA Lelystad

The Netherlands

Tel: +31(0)320-2300005

Fax: +31(0)320-282186

E-mail: [email protected]

WWW.NITEK.NL

USA Office:

5410 Newport Drive, Rolling Meadows, IL 60008

Phone: (800) 528-4343

Fax: (847) 259-1300

E-mail: [email protected]

WWW.NITEK.NET

685150102

Reduce risk of fire or electrical shock. Do not

expose this product to rain or moisture.

Installation

1) Check the twisted pair for continuity. Do this by shorting the pair of wires at one end and using an ohm

meter to check the resistance at the other end. The chart below will give you the length of your wires for a

measured resistance. Use a multimeter to make sure there is no voltage on the line.

For distances greater than 1,500 feet, there are several other systems available. Contact your local

Distributor or Nitek Technical Department for assistance.

The TR515x4 receiver can be used with any standard twisted pair video camera or Balun type transceiver device.

Steps 2 and 3 refer to the Nitek VB37 Balun.

Wire

Gage

300

(90)

500

(150)

1000

(300)

1500

(450)

2000

(600)

2500

(750)

3000

(900)

22 10 6 32 48 64 80 96

24 15 25 51 76 102 127 153

26 25 41 82 123 164 205 246

Distance in Feet (Meters)

Model TS515x4

Modular Active Video Receiver Card

w/Transmitters

Introduction

Twisted Sender has been designed by Nitek to transmit video signals over a point to point pair of wires. The wire

should be free of voltage or other outside signals. Twisted Sender can turn your in-house phone lines, leased

telephone lines or cable runs into pathways for video signals. Twisted Sender is ideal for shopping malls, parking

garages, remote gates, large factories, airports or any number of places where you need to connect video

equipment.

Receiver Unit Transmitter Unit

Size 1 card slot Size 1.3”H x 2.0”W x .95”D

Power Requirements Power supplied by Card Cage Power Requirements None

Input (4) Low voltage current loop Input-Video 1 vpp composite video

from transmitter unit Monochrome or Color

Output-Video (1) 1.0 vpp composite video

Monochrome or Color

1 2

Résumé du contenu

Page 1 - Model TS515x4

Note: This installation should be made by a qualified service person and conform with local codes. System Specifications TR515x4 includes the followin

Page 2 - Troubleshooting

Installation (cont’d) 2) Check the video input at the transmitter unit to make sure you have video present. Connect the video to the BNC jack of the

Modèles reliés TR515x4

Commentaires sur ces manuels

Pas de commentaire

Nitek TS515x4 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Nitek TS515x4. Nitek TS515x4 User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés TR515x4

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Nitek TS515x4